Realignment; Modes; How To Enter Each Mode; Panel Test Mode - Kenwood TK-5710 Service Manual

1. Modes

User mode

Panel test mode

PC mode
Firmware
programming mode
Clone mode
Self programming mode
Firmware version information
Clock adjustment mode
Mode
User mode For normal use.
Panel test mode Used by the dealer to check the fundamen-
tal characteristics.
Panel tuning mode Used by the dealer to tune the transceiver.
PC mode Used for communication between the
transceiver and PC (IBM compatible).
Data programming Used to read and write frequency data and
mode other features to and from the transceiver.
PC test mode Used to check the transceiver using the PC.
This feature is included in the FPU.
See panel tuning.
Firmware Used when changing the main program of
programming mode the flash memory.
Clone mode Used to transfer programming data from
one transceiver to another.
Self programming You can program the frequency,
mode signaling and other functions using only the
transceiver.
Firmware version Used to confirm the internal firmware
information version.
Clock adjustment Used by the dealer to adjust date and time.
mode

REALIGNMENT

Panel tuning mode
Data programming mode
PC tuning mode
PC test mode
Function
TK-5710

2. How to Enter Each Mode

Mode
User mode
Panel test mode
PC mode
Panel tuning mode
Firmware programming mode
Clone mode
Self programming mode
Firmware version information
Clock adjustment mode
3. Panel Test Mode
Setting method refer to ADJUSTMENT.
4. Panel Tuning Mode
Setting method refer to ADJUSTMENT.
5. PC Mode
5-1. Preface
The transceiver is programmed by using a personal com-
puter, programming interface (KPG-43) and programming
software (KPG-95D).
The programming software can be used with an IBM PC
or compatible. Figure 1 shows the setup of an IBM PC for
programming.
IBM-PC
KPG-95D
Fig. 1
5-2. Connection procedure
1. Connect the transceiver to the personal computer with
the interface cable.
2. When the POWER switch on, user mode can be entered
immediately. When PC sends command the transceiver
enter PC mode, and "PROGRAM" is displayed on the
LCD.
When data transmitting from transceiver, the red LED is
lights.
( ) (
B /5710H
Operation
Power ON
[PF1] + Power ON
Received commands from PC
[Panel test mode] + [GRP^]
[PF2] + Power ON
[PF5] + Power ON
[GRP^] + Power ON
[PF3] + Power ON
[PF4] + Power ON
KPG-43
)
B
5