Adjustment; Controls; Test Mode Operation Features - Kenwood TK-5710 Service Manual

( )
TK-5710 B

Controls

• KCH-14 (Basic control panel)
Power
switch
POWER
GRP
TX BUSY
VOL
MIC jack Volume Selector
• KCH-15 (Full-featured control panel)
Power
switch
POWER
CALL
GRP
TX BUSY
VOL
MIC jack Volume Selector
Panel Test Mode

■ Test mode operation features

This transceiver has a test mode. To enter test mode,
press and hold the [PF1] key while turning the transceiver
power ON. Test mode can be inhibited by programming. To
exit test mode, turn the transceiver power OFF.
• When the panel test mode is activated, the last used chan-
nel and signaling numbers are displayed. When the panel
test mode is activated for the first time, the channel and
signaling numbers are 1.
• If test signaling 20 (Tone Test Pattern) is selected, the re-
sult of Bit Error Rate (BER) calculation is displayed on the
LCD. The BER value is also output from the serial port.
54
( )
/5710H B

ADJUSTMENT

CH
PF1 PF2 PF3 PF4
key key key key
MON
MON SCAN SP OPT A B C OST
SCN
CH
PF1 PF2 PF3 PF4
key key key key
■ Key operation
Key
[Selector] Wide/Narrow/APCO
Shifts to the Panel tuning mode −
[GRP ]
[GRP ] Squelch off
[PF1] Test frequency channel down
[PF1] Hold Test frequency channel
continuation down
[PF2] Test frequency channel up
PF5
key
[PF2] Hold Test frequency channel
continuation up
[PF3] Test signaling down
[PF3] Hold Test signaling continuation down Signaling No.
[PF4] Test signaling up
[PF4] Hold Test signaling continuation up
[PF5] Function on
MIC PTT Transmit
MIC keypad Use as the DTMF keypad.
([0] to [9] and If a key is pressed during transmission,
[#], [*]) the DTMF corresponding to the key
that was presses is sent.
PF5
key
Key
[Selector] Function off
[GRP ] Squelch level 0
[GRP ] High power/Low power
[PF1] Compander on/off
[PF2] LCD all lights
[PF3] MSK 1200bps/2400bps
[PF4] Beat shift on/off
[PF5] Function off
MIC PTT Transmit
MIC keypad Function off
([0] to [9] and
[#], [*])
"FNC"not appears
Function Display
Wide :"W"appears
Narrow:"N"appears
APCO :"A"appears
MON icon appears
Channel No.
Channel No.
Channel No.
Channel No.
Signaling No.
Signaling No.
Signaling No.
"FNC" appears
−
−
"FNC" appears
Function Display
−
On :▼ icon appears
Low: SP icon appears
On : A icon appears
LCD all point appears
2400bps: CALL
icon appears
On : OS(KCH-14)
icon appears
On : OST (KCH-15)
icon appears
−
−
−