Read-Only Coils - Toshiba TOSVERT-130 G3 Interface Manual

efesotomasyon.com -Toshiba inverter,drive,servo,plc

9.5 Read-Only Coils

The following read-only "0X" coils are available via Modbus command 01. These coils
access the same bits which are detailed in holding register 06 (refer to section 9.2 of
this manual).
Coil Function
Run • stop status
11
12 Run enable status
Forward • reverse status
13
14 Acc / dec #1 / #2 selection status
15 Fault status
16 Jog mode status
17 Feedback enable status
18 Compulsory DC injection braking mode
status
19 Fundamental parameter switching status
1A Coast stop command status
1B Emergency off command status
1C Main circuit undervoltage (MSV) status
1D Reserved
1E Reserved
1F Reserved
20 Reserved
Bank
DPRAM OFF: Stopped
ON: Running
OFF: Run enabled
ON: Stopped
OFF: Reverse
ON: Forward
OFF: Acc / dec #1
ON: Acc / dec #2
OFF: Faulted
ON: Not faulted
OFF: Normal (acc/dec mode)
ON: Jog mode
OFF: Feedback valid
ON: Feedback invalid
OFF: DC injection braking inactive
ON: DC injection braking active
OFF: V/F #1
ON: V/F #2
OFF: Normal
ON: Coasting to stop
OFF: Normal
ON: Emergency off
OFF: Normal
ON: MSV
49
Function



