Table of Contents
Advertisement
Chapter 5 Preparation
5-1 Power Supply
A battery pack or AC power can be used as the power
supply for the camera-recorder.
Using a Battery Pack
Battery packs from the following manufacturers can be used:
•
Panasonic
•
Anton/Bauer
•
IDX
•
PACO
•
Sony
<Notes>
Other batteries may be used by changing the menu
setting, but system compatibility is not guaranteed.
Charge the battery pack with the battery charger before
using it. (Please refer to the battery charger's instruction
manual for information about charging.)
5-1-1 Mounting the Battery and Setting
the Battery Type
Using an Anton/Bauer Battery Pack
1
Mount the Anton/Bauer battery pack.
<For your information>
The Anton/Bauer battery holder includes both a power
supply output connector for lighting and a lighting control
switch, which are convenient when attaching a light. Please
contact Anton/Bauer for information about the lighting
system.
64
Power supply output
connector for lighting
Anton/Bauer
Battery Pack
Lighting control
switch
2
Insert the battery and slide it in the direction of the
arrow.
Release lever
<For your information>
Removing the battery pack
Completely push down and hold the release lever on
the battery holder. Then, slide the battery pack in the
opposite direction to the arrow while holding the lever
down.
3
Setting the battery type.
Select the battery type listed under BATTERY SELECT.
Select BATTERY SELECT from the <BATTERY/
P2CARD> screen in the MAIN OPERATION page.
Please refer to [8-6-2 BATTERY SETTING1] for more
information.
The following Anton/Bauer batteries can be
used:
•
PRO14
•
TRIM14
•
HYTRON50
•
HYTRON100
•
HYTRON120
•
DIONIC90
•
DIONIC160
<Note>
To use DIONIC, please set it as DIONIC90.
Advertisement
Table of Contents
