Table of Contents
Advertisement
Chapter 4 Adjustments and Settings for Recording
Information Item
P-REC (blink)
PRE RECORDING
indication/
SD memory card
remaining free
SD
space (when MODE
CHECK is being
performed)
ID
ID record
indication
PRO14 - AC_ADPT
Battery type
Battery remaining
level/voltage
EMP
MAX
REC
Camera-recorder
REC indication
P2 card remaining
free space
END
WP
LOOP
INFO P2
/
P2 card remaining
free space (when
MODE CHECK is
being performed)
S
Super iris ON/
B
super black ON
SB
.
Color temperature
Shutter speed/
1/60 - 1/2000
mode
SUPER V
Indication
Indicated while pre-recorded video and audio are being recorded on the P2
card. If the USER switch is set to perform the PRE REC function, either "P-
REC OFF" or the specified duration "1s - 8/15s" is displayed when the PRE
RECORDING mode is switched by pressing the USER switch.
If a video encoder card (AJ-YAX800G, optional accessory) is attached, the
remaining free space on the SD Memory card will be displayed when the
h
m
MODE CHECK button is pressed during proxy recording.
The ID is set to be superimposed on the video from the camera.
Battery type, selected through a menu option. When the AC adapter is
connected, it is indicated as AC_ADPT.
. V
Battery remaining level in tenths of a volt
%
Digital battery remaining level, as a percentage
Digital battery empty.
Digital battery fully charged.
The indication stays illuminated during recording. This is displayed when the
menu option REC TALLY of the SYSTEM MODE is set to "CHAR".
This can also be displayed during the recording using the AJ-SPC700E alone.
This is displayed when the menu option REC STATUS of the VF INDICATOR2
is set to "ON".
min
The indication "
when the remaining level is near zero.
When the card space is used up, "END" comes on.
The P2 card is write-protected.
The camera-recorder is in LOOP REC mode. When loop recording cannot be
performed, for example because the P2 card has no free space, the indication
blinks.
P2 card being recognised.
Total free space/capacities of the P2 cards (when MODE CHECK is being
performed).
<Note>
When the menu option P2 CARD REMAIN is set to "ONE CARD", the number
of the P2 card slot that contains the target card is indicated, together with the
remaining space.
For more information, see [P2 Card Remaining Free Space/capacity
Indication] (page 50).
min
The number of the P2 card slot that contains the target card and the
remaining free space (when MODE CHECK is being performed) are
indicated. In LOOP REC mode, the minimum guaranteed recording time is
indicated. This indication also appears when the target P2 card has been
switched with a user button.
The minimum guaranteed recording time refers to the sum, at the time loop
recording is stopped, of the remaining free space of available P2 cards,
except for the card with the largest remaining free space.
Example: If three P2 cards are available, with remaining space of eight
Super iris ON.
Super black ON.
Super iris and super black both ON.
K
Color temperature assigned to A, B, and PRE of the WHITE BAL switch (this
is a value stored at AWB performance or a value set through the menu
option). The indication is not provided in ATW mode.
1/
.
Shutter speed set to SYNCHRO SCAN.
Shutter speed fixed.
Shutter speed set to SUPER V (high vertical resolution mode).
Status
min" stays illuminated under normal conditions or blinks
minutes, five minutes and two minutes respectively, then the
minimum guaranteed recording time is seven minutes.
(continued)
49
4
Advertisement
Table of Contents
