Chapter 5 Preparation; Supplying The Power - Panasonic AJ-SDX900E Operating Instructions Manual

CONTENTS

Chapter 5 Preparation

5-1

Supplying the power

A battery pack or an AC power source can be used as this
unit's power supply.
To use the battery pack, there is the following
choice of makes of batteries:
≥Panasonic
≥Anton-Bauer
≥IDX
≥PACO
≥Sony
<Notes>
≥ Batteries of other makes can also be supported by changing
the setting menu but no guarantees are made for the
system when they are actually used with this unit.
≥ Before using the battery pack, recharge the battery using
the battery charger.
(For details on the recharging method, refer to the operating
instructions of the battery concerned.)
#< BATTERY/TAPE >
BATTERY SELECT
EXT DC IN SELECT
BATT NEAR END ALARM :OFF
BATT NEAR END CANCEL:ON
BATT END ALARM
BATT REMAIN FULL
TAPE NEAR END ALARM :ON
TAPE NEAR END TIME
TAPE END ALARM
TAPE REMAIN/∫
5-1-1 Attaching the battery and
setting the battery type
Using the Anton Bauer battery pack
1
Attach the battery pack made by Anton Bauer.
Power output connector for lighting
<Reference>
A battery holder made by Anton Bauer is equipped with a
power output connector for the lighting and a lighting control
switch to enable a light to be easily attached. For details on
the lighting systems available, contact Anton Bauer.
:PRO14
:AC-ADPT
:ON
:70%
:2min
:ON
:3min/∫
Battery pack made
by Anton Bauer
Lighting control
switch
2
Insert the battery pack and slide it in the direction of the
arrow.
Release lever
<Reference>
To remove the battery pack, slide it in the opposite direction to
the one in which it was attached while keeping the release
lever on the battery holder pulled down all the way.
3
Set the battery type.
Select the battery setting that corresponds to the battery
made by Anton Bauer for the BATTERY SELECT item on
the <BATTERY/TAPE> screen.
For details, refer to "Chapter 7 Menu description tables."
Usable batteries made by Anton Bauer:
• PRO14
• TRIM14
• HYTRON50
• HYTRON100
• DIGITAL14
• DIGITAL13
• DIONIC
5
57