Setting The Marker Displays; Marker Check Screen Displays; (Marker Select Button Function); Checking Return Video Signal In The Viewfinder - Panasonic AJ-SPC700E Operating Instructions Manual

Chapter 4 Adjustments and Settings for Recording

4-7-5 Setting the Marker Displays

The center, safety zone, safety zone area and frame markers
may be set to ON or OFF, along with specifications of the
marker types. To set and select markers, go to the <VF
MARKER> screen from the VF page and select the
appropriate options.
For directions on navigating the menu, see [4-6-2 Setting
Menu Options].
<Note>
The indication MKR:A at the upper right of the screen shows
the current indication status. To view TABLE B, press the
MARKER SELECT button. This changes the indication to
MKR:B, allowing you to view the settings.

4-7-6 Marker Check Screen Displays

(MARKER SELECT button function)

The viewfinder can display a screen that allows you to view
the marker settings of the AJ-SPC700E.
Pressing the MARKER SELECT button on the camera-
recorder switches the marker indication as follows.
Marker A Marker B No marker
If the menu option FRAME SIG is set to 16:9 as the
information of Marker A and 4:3 as the information of Marker
B, then the 16:9 and 4:3 view angles can easily be checked
with the button, as required.
52
4-7-7 Checking Return Video Signal in the
The viewfinder displays the return video signal input to the
GENLOCK IN connector while the RET button at the lens is
held down.
To enable this capability, select CAM RET for the menu
option RET SW. This option can be found in the <SW
MODE> screen, which is accessible from the CAM
OPERATION page.
MARKER SELECT button
(continued)
Markers
Center marker
The view angle specified through the menu
option FRAME SIG is displayed.
Viewfinder
Safety zone