Assembling The Scooter - Drive Medical Daytona 3 Owners Manual Instructions

INSPECTION AND MAINTENANCE

ASSEMBLING THE SCOOTER

SUGGESTIONS
The assembly process is essentially the disassembly process in reverse. First study the text
and photographs in the disassembly procedure before re-assembling the scooter.
1.Position the front and rear sections of the Daytona.
2.Align the lower curved locking brackets of the front section with the corresponding
pegs on the front of the rear section.
3.Holding the seat post, slowly pivot the rear section forward until the curved locking
brackets are fully connected onto the top rear pegs.
4. Secure the lock pin into the pin hole.
5.Loose tiller adjustment knob, raise the tiller to the desired position, and then tighten
the tiller adjustment knob.
6.Reinstall the batteries and secure them with the hook-and loop strap.
7.Connect the front-to rear harness and battery cables.
8.Reinstall the rear shroud.
9.Replace the seat and rotate it until it locks into its correct position.
WARNING
After assembling your scooter, make absolutely certain the tiller adjustment knob is fully
tightened.
26