Assembling The Scooter - Drive Medical Scout Owner's Handbook Manual

7.7 Disassembling the Scooter
Both the models of scooter can be disassembled in to
four pieces without tools: seat, front section, rear
section and battery pack
The procedure for disassembly is the same for both
scooters. Please perform the following steps:
Scout Electric Scooter
1. Push the Seat
Rotate Lever whilst
pulling up on the
seat to remove.
2. Turn the handle to
release the battery
pack, then lift out
the battery pack
from the main body
of the scooter.
3. Turn the tiller anti-
clockwise to loosen
tiller. Lower the
tiller and then turn
the tiller knob
clockwise to secure.
4. Lock front tiller by
pulling the locking
knob out and
turning 90º.
5. Pull up on the
Connecting Handle
to split the two
halves of the base.

7.8 Assembling the Scooter

3. Loosen the tiller adjustment knob and pull
up the tiller to the required height.
Retighten the knob to secure.
After assembling the Scout, make sure the
tiller adjustment knob is fully tightened.
The weights of the major component parts for the 4-
wheel Scout are below:
Seat – 7.2kg (15.9lb)
Front Section - 15.8kg (34.7lb)
Rear Section – 10.7kg (23.5lb)
Battery Pack – 9.2kg (20.2lb)
Page 10 of 14
1. Line up the two
sections of base.
Lift up the
handle and use
the handle to
slowly lower the
two parts so
they lock
together.
2. Unlock front
tiller by pulling
the locking knob
out and turning
90º.
4. Lower battery
pack in to the
compartment in
the scooter and
then turn the
handle to secure
the pack in
place.
5. Replace the seat
and rotate it
until it locks in to
its correct
position.
Owner's Handbook (Code: MS008_IFU 01/13)