The Security Settings - Cisco TelePresence System C20 Administrator's Manual

Cisco TelePresence System Quick Set C20 / C20 Plus and Profiles using C20
Contents Introduction

The Security settings

Security Audit Server Address
Enter the external/global IP-address to the audit syslog server.
Requires user role: AUDIT
Value space: <S: 0, 64>
Format: String with a maximum of 64 characters.
Example: Security Audit Server Address: ""
Security Audit Server Port
Enter the port of the syslog server that the system shall send its audit logs to. A user with AUDIT
rights is required to change this setting.
Requires user role: AUDIT
Value space: <0..65535>
Range: Select a value from 0 to 65535.
Example: Security Audit Server Port: 514
Security Audit OnError Action
Describes what actions will be taken if connection to the syslog server is lost. A user with AUDIT
rights is required to change this setting.
Requires user role: AUDIT
Value space: <Halt/Ignore>
Halt: If the connection to the syslog server is lost for more than a few seconds, the system will
reboot and try to establish connection. If connection is restored, the audit logs are respooled to
the syslog server, and the system starts up again.
Ignore: The system will continue its normal operation, and rotate internal logs when full. When
connection is restored it will again send its audit logs to the syslog server.
Example: Security Audit OnError Action: Ignore
Security Audit Logging Mode
Describes where the audit logs are recorded or transmitted. A user with AUDIT rights is required to
change this setting.
Requires user role: AUDIT
Value space: <Off/Internal/External/ExternalSecure>
Off: No audit logging is performed.
Internal: The system records the audit logs to internal logs, and rotates logs when they are full.
External: The system sends the audit logs to an external audit server.
ExternalSecure: The system sends the audit logs to an external audit server that is verified by
the Audit CA list.
Example: Security Audit Logging Mode: Off
D14637.06 Profile C20 and Quick Set C20 Administrator Guide TC4.2, July 2011.
Copyright © 2010-2011 Cisco Systems, Inc. All rights reserved.
Web interface Advanced settings Advanced settings
Security Session ShowLastLogon
When logging in to the system using SSH or Telnet you will see the UserId, time and date of the
last session that did a successful login.
Requires user role: ADMIN
Value space: <Off/On>
Example: Security Session ShowLastLogon: Off
Security Session InactivityTimeout
Determines how long the system will accept inactivity from the user before he is automatically
logged out.
Requires user role: ADMIN
Value space: <0..10000>
Example: Security Session InactivityTimeout: 0
49
Password protection
On: Set to On to enable the possibility to show information about the last session.
Off: Set to Off to disable the possibility to show information about the last session.
Range: Select a value from 0 to 10000 seconds. 0 means that inactivity will not enforce
automatically logout.
Administrator guide
Appendices Contact us
www.cisco.com