Connecting The Cisco Telepresence Touch 8" Controller - Cisco TelePresence System Quick Set C20 Administrator's Manual

Cisco TelePresence System Quick Set C20 and Profiles using C20
Contents Introduction
Connecting the Cisco TelePresence
Touch 8" controller
A C Series codec running software version TC4.1 or later can be
controlled using the Cisco TelePresence Touch 8" controller (as
alternative to the remote control.)
D14637.08 Profile C20 and Quick Set C20 Administrator Guide TC5.1, February 2012.
Copyright © 2010-2012 Cisco Systems, Inc. All rights reserved.
Web interface Advanced settings
Connecting the Touch controller
The Touch controller must be connected to the codec via
LAN. The connection is via the provided power adapter, as
illustrated above.
The process of associating the Touch controller to the codec
is called paring. Note that the codec is signalling that it is
available for pairing for only 30 minutes after it is switched on.
72
Password protection Appendices Appendices
Power
adapter
Codec address
Touch controller set-up
Once the Touch controller is connected to power, the set-up
procedure begins. Follow the instructions on screen.
If the codec is not in the list of available codecs displayed
on the Touch controller, you can select a codec manually by
entering its IP address.
If the Touch controller needs software upgrade, new software
will be downloaded from the codec and installed on the unit
automatically as part of the set-up procedure. The Touch
controller restarts after the upgrade.
You can verify that the Touch controller is successfully paired
to the codec by checking that the codec address is displayed
in the top banner.
If you want more details on Touch installation, please read the
Cisco TelePresence Touch 8 inch Installation Guide, which is
available on the Cisco web site.
Administrator guide
Contact us
To LAN socket (Ethernet)
To power socket
www.cisco.com