Table of Contents
Advertisement
Troubleshooting
Diagnosing switch indicators
TABLE 26
Symptom
Power LED is Off
Power LED is Amber
Diag LED is Amber
Link LED is Off
Power and cooling problems
If the power indicator does not turn on when the power cord is plugged in, you may have a problem
with the power outlet, power cord, or internal power supply. However, if the unit powers off after
running for a while, check for loose power connections, power losses or surges at the power outlet,
and verify that the fans on the unit are unobstructed and running prior to shutdown. If you still
cannot isolate the problem, then the internal power supply may be defective. In this case, contact
Technical Support for assistance.
Installation
Verify that all system components have been properly installed. If one or more components appear
to be malfunctioning (such as the power cord or network cabling), test them in an alternate
environment where you are sure that all the other components are functioning properly.
Brocade FastIron CX Switch Hardware Installation Guide
53-1001978-01
DRAFT: BROCADE CONFIDENTIAL
Troubleshooting chart
Action
•
Internal power supply is disconnected.
•
Check connections between the switch, the power cord, and the wall outlet.
•
Contact Technical Support.
Internal power supply has failed. Contact Technical Support.
•
The switch self test has detected a fault.
•
Power cycle the switch to try and clear the condition. If the condition persists,
contact Technical Support.
•
Verify that the switch and attached device are powered on.
•
Be sure the cable is plugged into both the switch and corresponding device.
•
Verify that the proper cable type is used and its length does not exceed specified
limits.
•
Check the adapter on the attached device and cable connections for possible
defects. Replace the defective adapter or cable if necessary.
Chapter
6
67
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
