Brocade Communications Systems FastIron CX Installation Manual page 32

2
Preparing the installation site
•
Use the following setps to mount devices in rack.
1. Remove the rack mount kit from the shipping carton. The kit contains two L-shaped mounting
2. Attach the mounting brackets to the sides of the device as illustrated in
NOTE
FCX624-E, FCX624-I, FCX648-E, and FCX648-I device brackets are mounted using three screws, as
shown in
FIGURE 24
FIGURE 25
3. Attach the device in the rack as illustrated in
22
DRAFT: BROCADE CONFIDENTIAL
Grounding: Rack-mounted equipment should be properly grounded. Particular attention should
be given to supply connections other than direct connections to the mains.
brackets and mounting screws.
Figure 25.
Figure 25.
Attaching the Brackets for FCX624S, FCX648S, FCX624S-F, FCX624-HPOE,
FCX648-HPOE
Attaching the brackets for FCX624-E, FCX624-I, FCX648-E, and FCX648-I
Figure 26.
Brocade FastIron CX Switch Hardware Installation Guide
Figure 24 and
53-1001978-01