Step 2: Select The Hardware Site; Power Requirements; Environmental Considerations; Step 3: (Optional) Wall Mount The Unit - Toshiba Stratagy Flash Installation Manual

Installation

Step 2: Select the Hardware Site

Step 2: Select the Hardware Site
➤
Since the Stratagy Flash and the telephone system must be physically connected, place the
Stratagy by the telephone system.

Power Requirements

We recommend the following for the Stratagy Flash unit:
•
A 15A circuit breaker and dedicated AC circuit that does not have an On/Off wall switch
(avoids accidental power interruption).
•
A UPS in areas where the power source is not stable (frequent power failures, brownouts, etc.).

Environmental Considerations

The area in which you locate the Stratagy Flash affects its operation. Place it in an appropriate area
that is:
•
Dry, clean, well ventilated, lighted (avoid placing it in direct sunlight), and easily accessible
•
Not subject to extreme hot or cold, corrosive fumes, dust, other airborne contaminants, or
excessive vibration

Step 3: (Optional) Wall Mount the Unit

➤
See the Stratagy Flash Wall-Mounting Template and Instructions included in the package for
instructions on wall mounting the unit.

Step 4: Program Strata

Strata CTX

Stratagy Flash is compatible with all Strata® CTXs. Strata CTX needs to recognize Stratagy
Flash's DTMF signaling. An ARCS card must be installed in the Strata CTX100 for this DTMF
signaling. Strata CTX670 allows four DTMF circuits in its default configuration.
•
Install and program an ARCS card in the Strata CTX100. When installed, the ARCS card by
default allows four circuits. Additional licenses may be required, depending upon the Strata
CTX configuration and applications.
•
Program slot in Strata CTX before installing the Stratagy. Refer to Strata CTX Programming
Manual for details.

Strata DK

The Stratagy Flash Voice Processing system works with all Strata DK424/DK280,
DK40i/DK40/DK16e/DK16, DK14/DK8 and DK24/DK56/DK96 (Release 4) systems.
•
Make sure there are enough single line (analog) station ports on the Strata DK to support the
number of Stratagy Flash ports required.
•
Strata DK needs to recognize the Stratagy Flash's DTMF signaling. Make sure an RRCS is
installed on the DK424i/DK424/DK280 RCTU, a K5RCU, K5RCU2 or K4RCU3 in the
DK40i/DK40/DK16e/DK16, or CRCU in the DK24/DK56/DK96.
8
Stratagy Flash Installation Guide 02/02