Step 5: Set Up Stratagy Flash System Hardware; Step 6: Verify Voice Playback, Basic Auto Attendant And Ports Are Functioning Correctly; Step 7: Install Stratagy Admin Software (Vsa.3X) - Toshiba Stratagy Flash Installation Manual

•
Run Program 03 and assign these code(s) where the DTMF receiver is installed:
DK424i/DK424/DK280
Code 92, 93, or 94 for slot 00
Note When DK14/DK8 is powered on, Program 03 automatically assigns the correct code for the
QRCU.

Step 5: Set up Stratagy Flash System Hardware

1. If the Stratagy Flash is not going to be wall mounted, place the unit in the site determined.
2. Connect the RJ11C line cords from the Strata single line (analog) station ports to the
corresponding Stratagy Flash port.
3. If using a UPS, plug it into a dedicated outlet.
Note A UPS is required in areas where the power source is not stable (frequent power failures,
brownouts, etc.).
4. Connect the six-ft. power supply cable included in the package.
Once you have connected the power supply cable, the Stratagy Flash performs a self test while
booting-up.
The Stratagy Flash voice ports are off-hook for a short period during startup while Stratagy
software loads. During that time, the status light is Off and should turn On when finished.
Step 6: Verify Voice Playback, Basic Auto
Attendant and Ports are Functioning
Correctly
➤
Dial the extension number for each port. Stratagy should (for each port):
•
Answer and play the Toshiba Plug and Play company greeting ("Thank you for calling..."),
greeting 1 in User ID mailbox 990.
•
Continue to play the Toshiba Plug and Play caller instructions greeting ("If you know the
extension of the person you wish to reach..."), greeting 1 in User ID mailbox 991.

Step 7: Install Stratagy Admin Software (VSA.3x)

Stratagy Admin Release 3 software is only supported by the Stratagy Flash and the
Important!
Stratagy DK Release 3 and cannot be used with other Release 2 systems.
Note Loading the Stratagy Admin software can be done before/after connecting the Stratagy
Admin PC to the Stratagy Flash.
The Stratagy Admin PC, connected to the Stratagy Flash (see
following specifications:
•
IBM compatible
•
3.5" 1.44MB (high-density) floppy disk drive
•
Hard drive with a minimum of 5MB of available disk space
•
DOS V6.2 or higher must be resident on the hard drive
•
580KB RAM memory free
Stratagy Flash Installation Guide
DK40i/DK40/DK16e/DK16
Code 92 for slot 00
02/02
Step 5: Set up Stratagy Flash System Hardware
DK24/DK56/DK96
Code 92 or 93
Step 8 on page 10), must meet the
Installation
9