Table of Contents
Advertisement
o IMPORTANT: Do not use a silicon sealant to seal the appliance
against the aperture. This will make it difficult to remove the hob
from the aperture in future, particularly if it needs to be
serviced.
o Carefully turn the hob back over and then gently lower it into the
aperture hole that you have cut out.
o There are holes on the base or the sides of the hob that you can
fix the four brackets to. There are three holes in each one of the
brackets.
o A seal will already be fixed to
the underneath of the hob when
it is supplied.
o You
should
bracket on the underneath
of the hob, in a position
that is appropriate for the
aperture that you have cut
out.
Using the screws
provided, fix the bracket
to the hob. These screws
MUST
tightened.
26
place
the
be
securely
Advertisement
Table of Contents
