Troubleshooting - Radio Shack Kameleon Owner's Manual

TROUBLESHOOTING

PROBLEM: No display at all times.
SOLUTION: Replace batteries with four new
AA alkaline batteries.
PROBLEM: The bottom two IR indicator
segments are flashing.
SOLUTION: Replace batteries with four new
AA alkaline batteries.
PROBLEM: No display when programming.
SOLUTION: Display has turned off due to
inactivity. Start programming
again and do not pause while
performing instructions.
PROBLEM: During programming, the bottom
IR segmentdisplay a long flash.
SOLUTION: An invalid entry has occurred.
Check the keys to be pressed and
start program again.
PROBLEM: How do I stop programming?
Press HOME once to return to the
SOLUTION:
Program Keys screen. Press HOME
once more to exit completely.
PROBLEM: The unit does not control home
entertainment devices or
commands are not working
properly.
SOLUTION: Try all listed codes for the device
brands being set up.Make sure
they can be operated with an
infrared remote control.
PROBLEM: Tried Searching For Your Code
method and still could not find a
working code.
SOLUTION: Perform Restoring Factory Default
Settings on page 22. Then repeat
Searching For Your Code on page
9.
PROBLEM: Cannot program a macro onto M1
– M4 or POWER keys.
SOLUTION: Make sure the total number of key
presses being programmed is less
than 15.
PROBLEM: Power macro does not execute.
First, press the Home Theater key
SOLUTION:
once, then press POWER once.
PROBLEM: Favorite channel function does
not work properly.
SOLUTION: Some devices (e.g.,Cable Boxes or
Satellite Receivers) use two-digit
channel numbers. During
programming, press ENTER or OK
once after entering a channel
number (e.g., 0 2 ENTER for
channel 2). See Programming
Favorite Channel Scan on page 21.
PROBLEM: Changing channels does not work
properly.
SOLUTION: If the original remote control
required pressing ENTER to
change channels, then press
ENTER on the remote control after
entering channel numbers.
PROBLEM: No remote control of volume.
SOLUTION: See Changing Volume Lock on
page 13 to lock/unlock volume.
PROBLEM: bottom IR segment flashes when
a key is pressed, but home
entertainment device does not
respond.
SOLUTION: Make sure the remote control is
aimed at your home
entertainment device and is not
farther than 15 feet away.
CH! and CH#do not work for
PROBLEM:
your RCA TV.
SOLUTION: Due to RCA design (1983-1987),
only the original remote control
will operate these functions.
PROBLEM: Pressing SCROLL one or times in
CD, DVD, PVR or Home Theater
mode, does not display a
secondary menu screen.
SOLUTION: Even though SCROLL is displayed,
for these modes, there are no
additional menu screens.
For more help, or if your issue is not listed, visit
www.radioshack.com or call 800-950-7044.
Troubleshooting/Troubleshooting 23
O ' M
WNER S ANUAL