Radio Shack Keychain Quick Manual

61-2663.fm Page 1 Wednesday, August 11, 1999 5:05 PM
Keychain-Remote Control System
Your RadioShack Keychain-Remote
Control System is a valuable accesso-
ry for your Wireless Remote Control
System. With this switch and trans-
ceiver you can individually turn on or
off lights or appliances from any loca-
tion in your home. Using the remote,
you can turn on and off a lamp or ap-
pliance, connected to the transceiver.
You can also turn on and off other
lamps or appliances attached to your
optional Plug 'n Power
This remote control system is compati-
ble with other Plug 'n Power systems
and controllers, all of which are avail-
able from your local RadioShack
store.
PREPARATION
1. Using a small screwdriver, set the
house code dial of the transceiver
and the dial of the remote (located
inside the remote's battery com-
partment) to the same letter.
Remote
I
E M
A
2. Set the slide switch inside the re-
mote's battery compartment to the
unit code of the lamps or applianc-
es you want to control (1 and 2, or
RadioShack and Plug 'n Power are registered trademarks used by Tandy Corporation.
®
receivers.
Your appliance switch requires two AAA
batteries (not supplied) for power. For
the best performance and longest life,
we recommend RadioShack alkaline
batteries.
Cautions:
Transceiver
Follow these steps to install batteries.
A
O C
1. Slide the battery compartment cover
M E
K
G
I
2. Place the batteries in the compart-
©
1999 Tandy Corporation.
All Rights Reserved.
5 and 6). Set the unit code on each
optional lamp/appliance module to
correspond to the same number set-
ting on the slide switch.
1, 2 5, 6
Note: Regardless of the slide switch
setting, the transceiver always turns
on a connected lamp or appliance
using Button 1.
• Use only fresh batteries of the re-
quired size and recommended type.
• Do not mix old and new batteries or
different types of batteries.
in the direction of the arrow to re-
move it.
ment as indicated by the polarity
symbols (+ and –) marked inside.