Disconnecting Cables; Setting Up The Cradle - Symbol Phaser P460 Reference Manual

Disconnecting Cables

To disconnect the scanner cable:
1. Power down all the devices connected to the scanner.
2. Remove the cable by twisting the twist-lock 1/8 turn counter-clockwise and pulling
the cable out.

Setting Up the Cradle

On the bottom of the cradle are three ports. COM1 connects to the host computer, COM2
is used for daisy-chaining multiple base stations together, and the Power port supplies power
to the cradle.
1. Connect an appropriate power supply to the Power port on the cradle. The indicator
light on the cradle blinks, signifying successful power-up.
2. Insert the cable from the host computer into COM1 and the cable to the other base
stations, if any, into COM2. Refer to
COM2
Figure 2-1. Ports on the Cradle
Figure 2-2. Power Supply Port
COM1
Connecting to a Host
Power port
on page 2-5.
Set Up
2-3