Introduction
This chapter covers the suggested maintenance of the LS 1006 scanner, as well as the technical
specifications, available accessories, pinouts, and beeper definitions.
Maintenance
Cleaning the exit window is the only maintenance required.
Do not allow any abrasive material to touch the window.
•
Remove any dirt particles with a damp cloth.
•
Wipe the window using a damp cloth, and if necessary, a non-ammonia based
•
detergent.
Do not spray water or other cleaning liquids directly into the window.
•
Cables
There is one cable available for use with the LS 1006; the PS/2 Keyboard Wedge Cable, part
number NA6022.
Optional Accessories
Optional accessories include various stands and holders, which are supplied at extra cost.
Additional units of standard accessories may also be purchased at extra cost.
Troubleshooting
If the scanner does not operate after you've followed the operating instructions:
Be sure the scanner is programmed for the terminal in use.
•
Make sure the scanner is programmed to read the type of bar code you are scanning.
•
Check for loose cable connections.
•
Check the symbol to make sure it is not defaced.
•
Try scanning test symbols of the same code type.
•
Be sure you are within the proper scanning range.
•
If the symbol is decoded, but not transmitted to the host terminal:
Be sure the proper host type is selected (See Chapter 4).
•
Maintenance and Specifications
3-3