Chapter 2. Set Up; Introduction; Unpacking; Cables - Symbol Phaser P460 Reference Manual

Introduction

This chapter covers the procedures for setting up the Phaser and its accessories.

Unpacking

Remove the scanner from its packing and inspect it for damage. If the scanner was damaged
in transit, call one of the telephone numbers listed in the section
page vii. KEEP THE PACKING. It is the approved shipping container and should be used if
you ever need to return your equipment for servicing.

Cables

The following cables are used with the Phaser scanner:
Charging Synapse (p/n 25-32944-01)
t
Charging RS-232 (p/n 25-33359-01)
t
Flash Download (p/n 25-33673-01)
t

Installing the Cable on the Scanner

Note: The P 360 does not have a cable interface.
1. Power down all devices that will be connected to the scanner.
Chapter 2
Set Up
Symbol Support Center on
2-1