Setting Up The Alarm - PACOM PDR16-PC User Manual

User's Manual

Setting Up the Alarm

 Select an alarm: Select an alarm icon
 Enable: Check the box to enable the selected alarm. When selecting Use alert sound on event, the DVR will
play alert sound through the attached speaker during alarm output. You can set up the DVR to play different alert
sounds for each type of event. Create sound files (.wav) for each type of event under program installation folder and
name the sound files: sensor.wav for alarm-in, motion.wav for motion detection and vloss.wav for video loss.
 From / To: Set the beginning and ending time (00:00 to 24:00) of alarm activation by holding down and dragging
the pointer.
NOTE: In cases where the From hour is later than the To hour, the alarm will be activated at the From time of the
current date until next day's To time. If you set To: 08:00 and From: 18:00, this means the alarm will be active over
night from 6:00 p.m. until 8:00 a.m. the following day.
 Dwell time: Set the alarm output duration (0 seconds to 30 minutes) by holding down and dragging the pointer.
18
to set up.