Maintenance / Proper Handling; Unfinalizing A Finalized Cd; Erasing The Last Recorded Track; Erasing All Tracks - Innovative Technology ITVS-750 Manual

Wooden music centre with recordable cd player
Hide thumbs Also See for ITVS-750:
Table of Contents

Advertisement

few minutes in some cases.
ERASING A CD-RW (CD-RW ONLY)
Erasing processes will only work on an unfinalized CD-RW disc.
If a CD-RW disc has been finalized, you will need to unfinalize it prior to erasure.
With a CD-RW, it is possible to erase either the last recorded track, or the entire disc.
All erasing processes are permanent – they cannot be undone.

Unfinalizing a Finalized CD

Note: Skip this process if the CD-RW has not been finalized.
1. With a finalized CD-RW loaded, press the "ERASE" button while in stopped mode. "UNF IN—d"
will appear on the display.
Note: To cancel the unfinalizing process at this point, press STOP ( ).
2. Press the PLAY (
on the display. When this message disappears, the disc is unfinalized.
Note: The unfinalization time is dependent on the contents that have been recorded, and may take a
few minutes in some cases.

Erasing the Last Recorded Track.

1. With an unfinalized CD-RW inserted, press the "CD" selector button.
2. In stop mode, press the "ERASE" button. "ErA" and the last recorded track number will appear on
the display.
3. Press the (
) button to begin erase the last track. "--- Busy" will appear on the display. It will
disappear, indicating that the track has been erased permanently from the CD-RW.
4. Repeat steps 2 and 3 to continue erasing tracks one at a time.
Note: If there are no tracks on the CD-RW, the "ERASE" button will have no effect.
Note: You will not be able to erase the last recorded track from CD-RW discs copied from another
device.

Erasing All Tracks

1. With an unfinalized CD-RW inserted, press the "CD" select button.
Note: To cancel the finalizing process at this point, press STOP ( ).
2. Press and hold the "Erase" button until "ErA ALL" appears on the display.
3. Press the (
) button to begin erasing all the tracks on the CD. "--- Busy" will appear on the
display. It will disappear, and 000 00:00" will appear to confirm that the disc is clear.
Compact Disc Handling
Always place the disc on the disc tray with the label side facing upward (compact discs can be played/recorded
only on one side)
To remove a disc from its storage case, press down on the center of the case and lift the disc
upward, holding it carefully by its edges.
To clean a disc, wipe the surface from the center hole outward towards the outer edge with a soft, dry cloth.
Never use such chemicals as record spray, antistatic sprays or fluid, benzine or thinner to clean discs; they will
irreparably damage the disc's plastic surface.
Discs should be returned to their cases after use to protect from dust and scratches.
Do not expose discs to direct sunlight, high humidity, or high temperature for extend periods of time.
Printable CD-R and CD-RW discs are not recommended, as the label side may become sticky and damage the
unit.
Use a soft oil-based felt-tipped pen to write the information on the label side. Never use a ball-point or
hard-tipped pen, as doing so may damage the recorded side.
Do not use irregularly-shaped CDs (octagonal, heart shaped, business card size, etc),
as they will damage the unit.
Read all precautions supplied with any CD-R or CD-RW disc
Never handle a disc with dirty fingers.
Never insert a disc that has a crack on the surface.
) button to start unfinalizing. "--- BUSY" will appear

Maintenance / Proper Handling

14

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ITVS-750 and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents

Save PDF