Table of Contents
Advertisement
Setup
1. Remove white protective needle cover by gently pulling towards front of unit.
2. Remove any packaging materials from the unit.
3. Connect the AC power cord
to a wall outlet.
Note: To prevent interference, avoid bundling audio signal cables together with the AC power cord.
Basic Operation
1. Switch the POWER toggle switch (1) to turn the unit on.
2. Select the source by pressing the corresponding mode
button (AUX / PHONO / AM/FM / CD / TAPE) (2).
3. Rotate the VOLUME knob (3) to adjust to the
desired sound level.
Listening through Earphones/Headphones (not included)
For private listening, first reduce the volume level to minimum.
Insert your headphones' plug into the PHONES jack, then
adjust the volume up by turning the VOLUME knob.
Note: The speakers will automatically be deactivated while
headphones are plugged in.
CONDENSATION WARNING:
When the unit is moved from a cold or warm place, or is used following a sudden temperature change, there is the
danger that water vapor in the air may condense on the unit, preventing proper operation. In such cases, leave
the unit for 1-2 hours after plugging it into an AC outlet to allow it to stabilize at the temperature of its surroundings.
When using the remote control, point it towards the remote sensor on the front panel of the unit.
Notes:
- Even if the remote control is operated within the effective range, remote control operation may be
impossible if there are any obstacles between the unit and the remote control.
- If the remote control unit is operated near other devices which generate infrared rays, it may not
function properly. Conversely, the other devices may not function incorrectly.
Battery Installation
1.
Remove the battery compartment cover.
2.
Insert 2x "AAA" batteries.
Note: Make sure that they are oriented so their polarity
markings, "+" and "-" match the remote's markings.
3.
Replace the battery compartment cover.
Setup / Basic Operation
Remote Control
6
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the ITVS-750 and is the answer not in the manual?
Questions and answers
Turntable won’t spin
The Innovative Technology ITVS-750 turntable may not spin due to the tone arm balancer being incorrectly adjusted. The silver screw on the back of the turntable acts as a balancer for both the turntable and the tone arm. Adjust this screw using a coin and test by moving the tone arm to the middle of the spindle. The tone arm should move freely to the end of the record without resistance before using the turntable.
This answer is automatically generated
The turntable won't spin.
The Innovative Technology ITVS-750 turntable may not spin due to the following reasons:
1. Tone Arm Balance Issue – The silver screw on the back of the turntable acts as a balancer for both the turntable and the tone arm. If it's not adjusted correctly, the tone arm may not move freely, preventing the turntable from spinning. Adjust the screw with a coin until the tone arm moves freely to the middle of the spindle.
2. Tone Arm Holder Secured – If the tone arm is still secured with the fixed rope, it will not function properly. Ensure the fixed rope is loosened and the tone arm is uplifted.
3. Protective Needle Cover Attached – The white protective needle cover must be removed before use. Gently pull it towards the front of the unit.
4. Power Connection Issue – Ensure the AC power cord is properly connected to a wall outlet.
If the turntable still does not spin after checking these points, further troubleshooting may be needed.
This answer is automatically generated
Need replace volume control switch
Need volume control #e-696oai-03
You can control the volume on the Innovative Technology ITVS-750 by turning the "VOLUME" knob. The volume ranges from 00 to 32.
This answer is automatically generated
When i turn the power on the screen lights up for 1-2 seconds and then no power. Nothing works. Where should I start ruling out things.