Twin Needle; Audible Alarm; Stitch Width Safety; Software Version - Husqvarna Viking Sapphire 875 Quilt User Manual

Twin needle

If you are using a twin needle, set the size of the needle to limit
the width of all stitches and prevent needle breakage. Activate
or deactivate the twin needle function with the OK button and
use the left/right arrow buttons to set the twin needle size. Your
setting will be saved even when the machine is turned off. A
pop-up message reminds you of the setting when you turn on the
machine. Close the pop-up message by pressing OK.
You cannot set the twin needle size if the Stitch
NOTE:
Width Safety is on, or turn on the Stitch Width Safety if
the machine is set for twin needle.

Stitch Width Safety

Use the OK button to turn on the Stitch Width Safety when
using a straight stitch needle plate or a straight stitch presser foot.
The stitch width will be limited to zero for all stitches to prevent
damage to the needle, presser foot and needle plate. This setting
is saved when the machine is turned off. A pop-up message
reminds you of the setting when you turn on the machine. Close
the pop-up message by pressing OK.

Buttonhole balance

If the Sensor One-Step Buttonhole Foot is not connected or if
you select stitch 1:25, the columns in the buttonhole stitch will
be sewn in different directions. On some fabrics this may cause
the columns to appear with different density. Use the left/right
buttons to balance the density between -7 and 7. The changes
only affect the selected stitch. If another stitch is selected or the
same stitch is selected again, the value is reset to the default value.
Free Motion Floating*
To sew in free motion with the included Embroidery/Darning
Foot R or with any optional Free Motion Floating presser foot,
set the machine in Free Motion Floating mode. The drop feed
teeth recommendation will be activated. The setting remains
when the machine is turned off. A pop-up reminds you of the
setting when you turn on the machine. Close the pop-up message
by pressing OK.
You cannot set the machine in Free Motion
NOTE:
Floating Mode if Free Motion Spring Action is activated
or vice versa.

Free Motion Spring Action**

If you are using any of the optional Free Motion Spring Action
presser feet, you need to set the machine in Free Motion Spring
Action mode. The drop feed teeth recommendation will be
activated. The setting remains when the machine is turned off. A
pop-up message reminds you of the setting when you turn on the
machine. Close the pop-up message by pressing OK.
30
Operating the machine

Audible Alarm

Turns on or off all alarm sounds of the machine. Default setting
is on. This setting is saved even if the machine is turned off.
Contrast
Adjust the contrast of the GraphicDisplay by using the left/right
arrow buttons. The value can be set between –20 to 20 in steps
of 1. The setting is stored even when the machine is turned off.
Language
Use the left/right arrow buttons to change the language of all
text in your machine. The language setting is saved even if the
machine is turned off.

Software Version

The software version currently loaded for the sewing machine is
displayed.
*Free Motion Floating
When you are sewing free motion in low speed the
foot will raise and lower with each stitch to hold the
fabric on the stitch plate while the stitch is being
formed. When sewing in high speed, the foot oats
over the fabric while sewing. The feed teeth must be
lowered and the fabric is moved manually. All stitches
can be sewn in free motion mode.
**Free Motion Spring Action
The Free Motion Spring Action presser feet follows
the up and down movement of the needle with help
of the spring and the arm on the presser foot. The
feed teeth must be lowered and the fabric is moved
manually. It is recommended to turn on the Stitch
Width Safety for the presser feet that are only intended
for straight stitch sewing.