Husqvarna Viking Sapphire 875 Quilt User Manual page 32

Restart the buttonhole?
If you are sewing a buttonhole and stop to adjust the length
settings you will get this question once you start sewing again. If
you select "Yes", the machine will restart and sew the buttonhole
from the beginning with the new settings. If you select "No", the
change will be cancelled and the machine will continue sewing the
rest of the buttonhole with the previous settings. Use the arrow
buttons to select "Yes" or "No" and press the OK button.
Sensor One-Step Buttonhole Foot line up -
"Adjust white area to white line"
When you insert the fabric for sewing a buttonhole, the wheel
of the Sensor One-Step Buttonhole Foot might move. A pop-up
message prompts you to line up the white area with the white
line. Line up the white areas and close the pop-up message by
pressing the OK button.
Sensor One-Step Buttonhole Presser Foot
connected
The Sensor One-Step Buttonhole Foot can only be used for the
buttonhole stitches recommended for the foot. If the Sensor
One-Step Buttonhole Foot is connected and you select a stitch
that is not possible to sew with the foot, this message will appear
when you start to sew. Remove the foot or select a buttonhole
that can be sewn with the Sensor One-Step Buttonhole Foot.
Close the pop-up message by pressing the OK button.
Machine set for free motion sewing
This message is shown when the machine is set to Free Motion
Floating or Free Motion Spring Action and you turn on the
machine. Close the pop-up message by pressing the OK button.
Bobbin thread low
Your machine stops when the bobbin is almost empty. Replace
the empty bobbin with a full one and close the pop-up message
by pressing the OK button.
Continue sewing without closing the pop-up
NOTE:
message if you want all thread on the bobbin to run out.
Remove thread from under stitch plate and
in bobbin area
(Only on 875 Quilt)
When this pop-up message appears clean thread and lint from the
area under the stitch plate to allow the Selective Thread Cutter
to cut properly. Close the pop-up message by pressing the OK
button.
32
(Only on 875 Quilt)
Operating the machine