Red/White Wire - Trunk Release / 2Nd Channel (-) Output; Black/Red Wire - Light Relay N/O (+/-) Input; Green/Violet Wire - Light Relay Com Output; White/Red Wire - Light Relay N/C Input - Excalibur AL-XX60-EDPB Installation Manual

18 Pin Secondary Wire Harness (cont'd)

RED/WHITE WIRE - TRUNK RELEASE / 2ND CHANNEL (-) OUTPUT

This output provides a 250mA negative output when the trunk release/CH2 function is activated
by the controller� The output will remain as long as the controller button(s) is held�
CONNECTION: Connect this wire to the vehicle's existing trunk release switch if it is a low current
negative circuit� If the circuit is a high current ground or a positive circuit, the use of a relay is re-
quired� NOTE: The built-in horn relay circuit can be programmed & utilized for trunk release
if not being used otherwise�

BLACK/RED WIRE - LIGHT RELAY N/O (+/-) INPUT

This circuit provides the constant feed input for the built-in 10 amp domelight relay. Specifically
the normally open pin (pin 87)� This relay can be programmed via installer feature #5 for other
functions�
CONNECTION: Connect this wire to constant power or chassis ground as needed for the chosen
function�

GREEN/VIOLET WIRE - LIGHT RELAY COM OUTPUT

This circuit provides the output for the built-in 10 amp domelight relay. Specifically the common
pin (pin 30)� This relay can be programmed via installer feature #5 for other functions�
CONNECTION: Connect this wire to the vehicle circuit chosen to be driven� By default, connect to
the vehicle's domelight circuit�

WHITE/RED WIRE - LIGHT RELAY N/C INPUT

This circuit provides the input for the built-in 10 amp domelight relay. Specifically the normally
closed pin (pin 87a) which is typically only used for polarity reversing circuits� This relay can be
programmed via installer feature #5 for other functions�
CONNECTION: Connect this wire to constant power or chassis ground as needed for the chosen
function�

VIOLET/BLACK WIRE - HORN RELAY N/O (+/-) INPUT

This circuit provides the constant feed input for the built-in 20 amp horn relay. Specifically
the normally open pin (pin 87)� This relay can be programmed via installer feature #19 for other
functions�
CONNECTION: Connect this wire to constant power or chassis ground as needed for the chosen
function�

BLUE/BLACK WIRE - HORN RELAY COM OUTPUT

This circuit provides the output for the built-in 20 amp horn relay. Specifically the common pin
(pin 30)� This relay can be programmed via installer feature #19 for other functions�
CONNECTION: Connect this wire to the vehicle circuit chosen to be driven� By default, connect to
the vehicle's domelight circuit�

BROWN/BLACK WIRE - HORN RELAY N/C INPUT

This circuit provides the input for the built-in 20 amp horn relay. Specifically the normally
closed pin (pin 87a) which is typically only used for polarity reversing circuits� This relay can be
programmed via installer feature #19 for other functions�
CONNECTION: Connect this wire to constant power or chassis ground as needed for the chosen
function�
6