Engine Cooling Water Intake Valve; Battery Disconnect Switch; Nautique Electrical System - CORRECT CRAFT 200-OB Owner's Manual

Engine Cooling Water Intake Valve

Your boat is equipped with a valve (seacock) on the engine cooling
water intake. The handle has a slide mechanism to prevent the
valve from being shut off inadvertently. The valve is used to shut off
the water supply in the event a hose failure or water leakage occurs.
The valve is open when the yellow handle is in-line with the valve
body and the valve is closed when the handle is perpendicular to
the valve body. Leave the valve open at all times unless an
emergency condition requires you to close the valve to stop a leak
or the possibility of a leak. The valve is located on the starboard side
of the transmission.

Battery Disconnect Switch

The battery disconnect switch allows you to isolate all power to the
boat. This switch provides positive disconnect of the battery to
protect against tampering, electrical fire hazards and battery
rundown. Rotate the switch to the OFF position when the boat is
not in use.

Nautique Electrical System

To ensure proper electrical system boot up when using the battery
switch, please wait at least 30 seconds after turning the switch on
before entering the user code and starting the boat. Failure to do
this can disrupt the Accessory circuit causing the LINC display,
Stereo, Zero Off, and various electrical components not to turn on.
If the operator accidentally disrupts the Accessory circuit, press and
hold "Stop" for 2 seconds; then restart the system to regain
functionality of the Accessory circuit and the components
dependent upon it.
Controls and Indicators
RAW WATER
STRAINER
ON
WATER
VALVE
OFF
CORC067
4-59