Configuring The Junos Internet Software - Juniper Internet Router M160 Hardware Manual

Configuring the JUNOS Internet Software

The router is shipped with the JUNOS Internet software preinstalled and ready
to be configured when the router is powered on. There are three copies of
the software: one on a nonrotating flash drive in the Routing Engine, one
on a rotating hard drive in the Routing Engine, and one on a PC card that
can be inserted into the slot in the Routing Engine faceplate.
When the router boots, it first attempts to start the image on the PC card. If
a PC card is not inserted into the Routing Engine or the attempt otherwise fails,
the router next tries the flash drive, and finally the hard drive.
You configure the router by issuing JUNOS command-line interface (CLI) commands,
either on a console device attached to the
connection to a network connected to the
Gather the following information before configuring the router:
To configure the software, follow this procedure:
1.
2.
3.
4.
5.
Name the router will use on the network
Domain name the router will use
IP address and prefix length information for the Ethernet interface
IP address of a default router
IP address of a DNS server
Password for the root user
If the router is not already turned on, power it on as described in "Powering On
the Router" on page 119.
Log in as the "root" user. There is no password.
Start the CLI.
root# cli
root@>
Enter configuration mode.
cli> configure
[edit]
root@#
Configure the name of the router. If the name includes spaces, enclose the
name in quotation marks (" ").
[edit]
root@# set system host-name host-name
Connecting the Router and Performing Initial Configuration
port on the CIP, or over a telnet
CONSOLE
port on the CIP.
ETHERNET
Configuring the JUNOS Internet Software
121