Table of Contents
Advertisement
Available languages
Available languages
STEP 12
INSTALL MOUNTING BRACKETS
You will need the mounting brackets and 2 #8 hex-head
screws set aside in Step 1.
You must install the mounting brackets onto the
dishwasher tub frame top or sides prior to sliding
the dishwasher into place under the countertop. This
dishwasher is capable of a true-flush installation at a
24" deep opening. The mounting brackets have several
available attachment positions to accommodate different
cabinet constructions.
Install mounting brackets on top if the underside of
countertop is wood or wood-like material that accepts screws:
IMPORTANT -
After installing brackets and before
closing the dishwasher door, adjust the brackets by
bending them up as needed, so that they do not contact
the top of the dishwasher door and cause damage.
Top Mounting
#8 Bracket
Screw
Dishwasher
Bend and break here
tub frame
after installing if
counter has a short
overhang.
• If you are installing the dishwasher under a counter
with a short overhang, the countertop brackets may
extend beyond the edge of the counter. If this is the
case, remove the excess length by repeatedly bending
the brackets at the front notch only until they break.
Install mounting brackets on sides
is granite or similar material that will not accept wood screws:
• Break off front portion of the tab with pliers at the
location shown prior to attaching to dishwasher.
• Position the left-hand side bracket as shown. Repeat
with the right bracket.
Side Mounting
Dishwasher
tub frame
#8 Bracket
screw as
supplied
Do not pinch
the latch
wires in
#8 bracket
Figure T
screw
Dishwasher Installation
Bracket
Figure S
if the countertop
Tub trim
Care should be taken
to ensure mounting
screws do not damage
cabinetry
Bend and break
here if necessary
Bracket
10
STEP 13 PUSH DISHWASHER INTO
FINAL POSITION
Check the tub insulation blanket, if equipped, to be sure
•
it is smoothly wrapped around the tub. It should not be
"bunched up" and it must not interfere with the door
springs. If the insulation is "bunched up" or interfering
with the springs, straighten and re center the blanket
prior to sliding the dishwasher into its final position.
• Slide the dishwasher into the final position by pushing
on the sides of the door panel. Do not push or pull
the door in a partially open or closed position when
moving the dishwasher. Do not use a knee or push on
the center of the panel. If you do, damage to the panel
will likely result. Check that the dishwasher is squarely
positioned in the cabinet opening at both the top and
the bottom of the appliance prior to mounting to the
cabinet.
Advertisement
Table of Contents
