Speedometer/Lcd Gauge - Arctic Cat XR 500 Operator's Manual

Code
C1320 Incorrect Vehicle Speed-to-RPM
Ratio
C1321 Vehicle Speed Erratic
C1322 Engine RPM Lost
C1323 "EPS OFF" Gauge Display
C1324 Loss of CAN communication with
EPS unit
C1325 Dual Loss
C1326 Rotor Position Encoder
C1327 Voltage Converter Error (Low)
C1328 Voltage Converter Error (High)
C1329 Internal Data Error

NOTE: Turn the key switch to the
OFF position then back to the ON
position to reset the malfunction
code. If the code continues to be dis-
played, take your ATV to an autho-
rized Arctic Cat Dealer for EPS
system servicing before resuming
operation.
CAUTION
Never operate this ATV with an EPS
code indicated on the LCD gauge/
speedometer. This indicates a mal-
function in the EPS system control
circuit and could result in a loss of
power steering assist.
In the event of electrical power failure,
the EPS system becomes disabled (simi-
lar to an automobile with the engine shut
off). Steering effort increases but steering
control can be maintained.
Speedometer/LCD
Gauge
1. Left Button - Shifts top display
through speedometer, RPM, and
clock.
Fault Description
WT103B
2. Middle Button - Shifts middle display
through speedometer, RPM, clock,
odometer, trip 1, trip 2, and engine
hours.
3. Right Button - Shifts bottom display
through coolant temperature, battery
voltage, intake air temperature, fuel
level, and tachometer.
4. Speedometer/Tachometer/Clock Dis-
play - Indicates approximate vehicle
speed in MPH or KM/H when speed-
ometer function is selected, RPM when
tachometer function is selected, or time
when clock is selected. Press the Left
Button to change which parameter is
being displayed. With speedometer
selected, press and hold the Left Button
to shift between standard (MPH/miles/
Fahrenheit) and metric (km/h/kilome-
ters/Celsius).
To set the clock, use the following pro-
cedure.
A. With the clock mode selected, press
and hold the Middle Button to set
the clock. Press the Left or Right
Button to alternate between 12-
hour or 24-hour modes.
B. Press the Middle Button to set the
hours. Press the Left button to
decrease the hours or the Right
Button to increase the hours.
C. Press the Middle Button to set the
minutes. Press the Left Button to
decrease the minutes or the Right
Button to increase the minutes.
D. When the proper time has been set,
press the Middle Button to return to
the main gauge display.
5. Engine Hour Meter/Odometer/Trip
Meter/Speedometer/Tachometer/
Clock Display - Displays engine
hours, odometer, trip meter, speedom-
eter, tachometer, or clock. Press the
Middle Button to change which
parameter is being displayed. The
Engine Hour Meter and Odometer
cannot be reset. To reset the trip
meter, select the Trip Meter; then
press and hold the Middle Button
until the trip meter display reads 0.
51