Manual Operation; Manual Controls - Dimplex Xpression SP220 Installation And Operating Instructions Manual

Manual Operation

The Standby Switch (Switch 1) must be first turned 'ON' and
the AUTO/MAN (Switch 2) switch set to 'MANUAL' to operate
the manual controls - see Fig 6.
Note : When the fire is put in Manual mode the first time the
flame effect will come on indicated by the Bottom neon coming
on for 3 seconds - see Fig 7.
Standby (ON/OFF)
(Switch 1)
Manual/Automatic
(Switch 2)
(1kW/2kW) Heat
(Switch 3)
Dimmer
(Switch 4)

Manual Controls

Setting Operation
Flame Effect
Flame Effect & 1Kw Heat Press the ' I ' button (Switch 3)
Flame Effect & 2Kw Heat Press the ' I ' button again (Switch 3)
To go to the previous settings press the ' O ' button (Switch
3).
To increase or decrease the brightness of the flames, use
the dimmer button (Switch 4). You can have any setting
between full brightness and the flames totally off. The heat
setting will remain the same.
To turn off the power the Standby Switch (Switch 1) must be
turned 'OFF'.
Note : Every time that manual mode is selected the previous
light and heat settings come on automatically.
AUTO
OFF
ON MAN.
Fig. 6
Neon's for
indicating
operation
level
outline of
wall fire
Fig. 7
Indication
Bottom Neon
Middle Neon
Top Neon