Dimplex SP1 Wallfire Installation And Operating Instructions Manual

Wall fires

The product complies with the European Safety Standards EN60335-2-30 and the European Standard Electromagnetic Compatibility

(EMC) EN55014, EN60555-2 and EN60555-3 which cover the essential requirements of EEC Directives 73/23 and 89/336

SP1 Wallfire

SP2 Wallfire

SP3 Wallfire

SP8 Wallfire

(UK)

08/19217/2 - Issue 2

Table of Contents

Need help?

Do you have a question about the SP1 Wallfire and is the answer not in the manual?

Page 1 SP1 Wallfire SP2 Wallfire SP3 Wallfire SP8 Wallfire (UK) 08/19217/2 - Issue 2 The product complies with the European Safety Standards EN60335-2-30 and the European Standard Electromagnetic Compatibility (EMC) EN55014, EN60555-2 and EN60555-3 which cover the essential requirements of EEC Directives 73/23 and 89/336...
Page 2 min. 300 min. 300 min. min. 300 min. min. 300 min.
Page 5: Installation And Operating Instructions
Installation and Operating Instructions Dimplex Wall Fires Model(s): SP120, SP220, SP320 & SP820 IMPORTANT: THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE General features of remote control are: Important Safety Advice: • Heat output can be increased or decreased according to your particular requirements.
Page 6: Lamp Replacement
Manual & Remote Operation Care is needed to avoid the front panel falling forward while removing the screws see Fig. 9a. Setting Operation Setting While holding the front by its sides with both hands carefully tilt Flame Effect Bottom Neon forwards and then lift up and out - see Fig.
Page 8 Hampshire. SO30 2DF Republic of Ireland Tel. 01 8424833 [c] Glen Dimplex UK Limited All rights reserved. Material contained in this publication may not be reproduced in whole or in part, without prior permission in writing of Glen Dimplex UK Limited.

Sp2 wallfireSp3 wallfireSp8 wallfire