- see ‘Installation’. AND REQUIRE SPECIALIZED FIXING DEVICES TO SP420, SP14, SP920 & SP19 - When in operation there is a PROVIDE A SAFE,SECURE INSTALLATION. 300 watt heat output from the fuel effect, and an additional The installation of this fire should be carried out by a 120 watt output when the heated glass panel is in operation.
(see Fig. 9). To gain access to the bulbs remove the screws at ‘A’ to remove Manual Operation - SP420, SP14, SP920 & the cover bracket ‘X’ - see Fig. 9. SP19 To gain access to the lamps, using a coin edge or screw The switches are located at the bottom right side of the heater.
Should you require after sales information or assistance Take care not to over-tighten the lamp. with this product please go to www.dimplex.co.uk wher you will find our self help guide by clicking on “After Sales” Steps for reassembling the heater...
Page 8
WEBSITE: www.dimplex.co.uk Southampton Hampshire. SO30 2DF [c] GDC Group Ltd, All rights reserved. Material contained in this publication may not be reproduced in whole or in part, without prior permission in writing of Dimplex, A division of GDC Group Ltd.
Need help?
Do you have a question about the SP420 and is the answer not in the manual?
Questions and answers