Advertisement
Products comply with the European Safety Standard: EN 60335-2-30 and the European Standards for Electromagetic Compatibility (EMC)
EN55014-1 / A2: 2002 and EN55014-2:2003 which cover the essential requirements of EEC directives 73/23 and 89/336
(SP4) SP420
(SP5) SP520
(SP9) SP920
08/19222/6 (UK) - Issue 6
Advertisement
Table of Contents
Related Manuals for Dimplex (SP4) SP420
Summary of Contents for Dimplex (SP4) SP420
- Page 1 Products comply with the European Safety Standard: EN 60335-2-30 and the European Standards for Electromagetic Compatibility (EMC) EN55014-1 / A2: 2002 and EN55014-2:2003 which cover the essential requirements of EEC directives 73/23 and 89/336 (SP4) SP420 (SP5) SP520 (SP9) SP920 08/19222/6 (UK) - Issue 6...
- Page 2 SP420 min. 300 min. (600 recommended) SP420 SP520 SP920 SP520 1200 min. 300 min. (600 recommended) 1158 1146 1158 SP920 1010 min. 300 min. (600 recommended) AUTO SP420 SP920 SP520...
- Page 3 SP420 SP520 SP420 SP920 SP520 & SP920 SP520 & SP920...
-
Page 4: Warning! This Appliance Must Be Earthed
Wall Fires - Models: SP420, SP520 & SP920 IMPORTANT: THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE Important Safety Advice When using electrical appliances, basic precautions should be followed to reduce the risk of fire, electric shock, and injury to persons, including the following: If the appliance is damaged, check immediately with the supplier before installation and operation. -
Page 5: Remote Operation
This section provides step by step instructions for selecting a location and preparing the site to install the fireplace into the following: Existing Fireplace 1. Make sure that the fire is located on a flat surface. 2. Seal all draughts and vents to prevent chimney debris from falling onto the Fireplace Insert. -
Page 6: Lamp Replacement
WARNING – ALWAYS DISCONNECT FROM THE POWER SUPPLY BEFORE REMOVING LAMPS. Warning - The lamps reach high temperatures during operation. For this reason, allow the lamps to cool down after switching off the appliance. The front panel will need to be removed in order to change lamps –... -
Page 7: After Sales Service
WARNING – ALWAYS DISCONNECT FROM THE POWER SUPPLY BEFORE CLEANING THE HEATER. For general cleaning use a soft clean duster – never use abrasive cleaners. The glass viewing screen should be cleaned carefully with a soft cloth. DO NOT use proprietary glass cleaners. - Page 8 [c] Dimplex UK Limited All rights reserved. Material contained in this publication may not be reproduced in whole or in part, without prior permission in writing of Dimplex UK Limited. UK customer help line 8.00am–5.00pm Mon-Fri and 8:30am-1.00pm Sat (October-March) Technical Services: Tel.