Table of Contents
Advertisement
5.2 REMOTE CONTROL OPERATION
Warning: It takes some time for the receiver to respond to the transmitter. Do not press the buttons more than once
within two seconds for correct operation.
Operation
Setting
Flame effect
Flame effect & 750W heat setting
Flame effect & 1500W heat setting
To turn off any of the settings press the 'O' button once.
To increase or decrease the brightness of the fuel effect use the buttons ( ) as shown in Fig. 5.
5.3 MANUAL OPERATION
Note: The Standby Switch (see 'a' in Fig. 6) must be first turned on to operate either the manual or the remote controls.
The red indicator mark on the switch will be visible
Setting
Flame effect
Flame effect & 750W heat setting
Flame effect & 1500W heat setting
To turn off any of the settings press the 'O' button once.
To increase or decrease the brightness of the fuel effect use the buttons ( ) as shown in Fig. 6.
5.4 THERMAL SAFETY CUT-OUT
For your safety, this appliance has been fitted with thermal cut-out. In the event that the product overheats, the cut-out
switches the heat off automatically.
To bring the heat back into operation, remove the cause of the overheating, then unplug or turn off the electrical supply
to the heater for up to 10 minutes.
When the heater has cooled sufficiently, re-connect and switch on the heater.
6. CLEANING AND MAINTENANCE
Warning:
Always disconnect from the power supply before attempting any maintenance.
6.1 CLEANING
Before commencing cleaning, unplug the heater and allow it to cool.
The surface of the heater should be given an occasional wipe over with a soft damp cloth. Do not use detergents
abrasive cleaning powder or polish on the body of the heater. The glass screen should be cleaned carefully with a
chamois leather. Do not use proprietary glass cleaners.
6.2 LAMP REPLACEMENT
To gain access to the lamps.
1.
Remove the front frame (see 'x' in Fig. 7) by lifting out then up and carefully leave to one side.
2.
Remove the three screws (see 'y' in Fig. 7) on the fuel effect.
3.
Slide the fuel effect out, by holding the front ledge and set aside carefully (taking care not to damage the logs as
they are fragile) – see Fig. 7.
4.
For access to the bulbs, carefully rotate the flexible rotisserie out of position ensuring that the rubber grommet is
not lost – see Fig. 8.
5.
Unscrew the defective lamp anti-clockwise. Replace with a 230V, 60W E14 SES lamp, do not over tighten (see
Fig. 8).
6.
Refit the fuel effect (with three screws) and Front Panel.
- 3 -
Operation
Press the 'I' button once
Press the 'I' button again
Press the 'I' button again
when it is turned on.
Operation
Press the 'I' button once
Press the 'I' button again
Press the 'I' button again
UK
Indication
Left Neon
Left & Middle Neon
All 3 neon's
Indication
Left Neon
Left & Middle Neon
All 3 neon's
Advertisement
Table of Contents
