Remote Control Operation; Manual Operation - Dimplex Valencia Installation And Operating Insctruction Manual

5.2 REMOTE CONTROL OPERATION

Warning: It takes some time for the receiver to respond to the transmitter. Do not press the buttons more than once
within two seconds for correct operation.
Decrease Brightness
Operation
Setting
Flame effect
Flame effect & 750W heat setting
Flame effect & 1500W heat setting
To turn off any of the settings press the 'OFF' button once.
To increase or decrease the brightness of the fuel effect use the buttons as shown in Fig. 6.

5.3 MANUAL OPERATION

Decrease Increase
Brightness Brightness
Operation
Setting
Flame effect
Flame effect & 750W heat setting
Flame effect & 1500W heat setting
To turn off any of the settings press the 'O' button once.
To increase or decrease the brightness of the fuel effect use the buttons as shown in Fig. 7.
Off Button
Operation
Press the 'ON' button once
Press the 'ON' button again
Press the 'ON' button again
Off On
Operation
Press the 'I' button once
Press the 'I' button again
Press the 'I' button again
- 4 -
Standby Switch
O
O
F
N
F
Fig. 7
On Button
Increase Brightness
Fig. 6
Indication
Bottom Neon
Bottom & Middle Neon
All 3 neon's
Note: The Standby Switch
must be first turned on to
operate either the manual or
the remote controls. The red
indicator mark on the switch will
be visible when it is turned on.
Indication
Bottom Neon
Bottom & Middle Neon
All 3 neon's