Separating Copies By Sets ("Sort" Setting) - Konica Minolta bizhub C203 Copy Operations

3
3.12.1

Separating copies by sets ("Sort" setting)

0 As the factory default, "Group" is selected.
0 If finisher FS-519 is installed, the output tray can be selected. For details, refer to "Selecting the output
tray" on page 3-74.
0 If offset sorting is selected while no finisher or separator is installed, printed copies will be fed out and
sorted in an alternating w and v pattern if the following conditions are met.
A4- or B5-size paper is used.
Paper of the same size and type is loaded with the w orientation in one paper tray and with the v
orientation in another tray.
The "Auto" Paper setting is selected.
The "Auto" Paper setting is not selected when the "Mixed Original" setting is selected.
0 If offset sorting is selected while a finisher or a separator is installed, printed copies are fed out and
stacked on top of each other with each set shifted to separate it.
1
In the Basic screen, touch [Finishing].
The Finishing screen appears.
2
Touch [Sort].
– To separate each set of copies, touch [Yes] under "Offset".
3
Touch [OK].
The Basic screen appears again.
3-72
Basic copy operations
bizhub C353/C253/C203 (FE2)