Sony HKCU1001 Installation Manual page 20

AU-302 board
D5 D7 D9 D11 D13 D15 D17 D19 D21
D6 D8 D10 D12 D14 D16 D18 D20 D22
A B
S1
D4 D3
1
RV1
D1 D2
2
AU-302 (Side A)
Ref.No. Name
D1 MAIN POWER
D2 CAMERA POWER
D3 CABLE ALARM OPEN
D4 CABLE ALARM SHORT Refer to the Operation Manual.
D5-D10 RED TALLY
D11-D16 GREEN TALLY
S1 MIC
S2 INCOM
S3 INCOM-RECEIVE
S4 FRONT MIC
S5 UNBALANCE
RV1 INTERCOM
1-14 (E)
C
S2
S3
S5
S4
Function
Refer to the Operation Manual.
Refer to the Operation Manual.
Refer to the Operation Manual.
Refer to the Operation Manual.
Refer to the Operation Manual.
Refer to the Operation Manual.
Selects the line to which the INCOM connector on the front panel is connected. PROD
PROD : Producer line
PRIV: Private (When the unit is disconnected from the producer line or engineer
line, only the intercom between the unit and the camera is possible.)
ENG : Engineer line
For switching between a voice and PGM for the front intercam reception.
PGM-OFF: The FP-INCOM reception becomes a voice.
PGM-ON : The FP-INCOM reception becomes PGM.
* Switching of receipt is valid when the INCOM MIX switch is set to OFF.
Sets the microphone input level according to the type of headset microphone to
be connected to the INCOM connector on the front panel.
DYNAMIC : Dynamic microphone (_60 dB) - The power is not supplied.
ECM : Electret condenser microphone (_40 dB) - The power is supplied.
CARBON : Carbon microphone (_20 dB) - The power is supplied.
Select ON/OFF according to the headset microphone type connected to the
INCOM connector on the front panel.
ON: For the unbalanced type (UNBALANCE)
OFF: For the balanced type
Refer to the Operation Manual.
Factory default setting
_
_
_
_
_
_
_
OFF
CARBON
OFF
HDCU3300/IM (J.E)