Sym HD 125 Service Manual page 94

To this chapter contents
8. V-BELT DRIVING SYSTEM/KICK STARTER
Installation
Caution
Pull out driven face to avoid it closing.
Driven face
Install driving belt onto driven pulley.
Install the driven pulley that has installed the belt
onto drive shaft.
On the drive belt another end to the movable drive
face.
Install the clutch outer with universal holder, and
Clutch outer
then tighten nut to specified torque value.
Torque value: 5.0~6.0kgf-m
Nut
Universal holder
Install the drive face with universal holder, and
then tighten nut to specified torque value.
Torque value: 5.0~6.0kgf-m
Universal holder
8-5