Side Stand; Cushion; Nuts, Bolts Tightness - Sym HD 125 Service Manual

Side Stand

Check side stand spring for damage or looseness.
Press down side stand and pull it with spring
gauge. If gauge reading is over 2 kg, it means that
the spring capacity is in normal.
Check if side stand set is operated smoothly.
Make sure that side stand is no bending or
deformation.

Cushion

Warning
Do not ride the motorcycle with poor cushion.
Looseness, wear or damage cushion will make
poor stability and drive-ability.
Front cushion
Press down the front cushion for several times to
check it operation.
Check if it is damage
Replace relative parts if damage found.
Tighten all nuts and bolts.
Rear Cushion
Press down the front cushion for several times to
check it operation.
Check if it is damage
Replace relative parts if damage found.
Park motorcycle with main stand.
Turn the rear wheel forcefully and check if engine
bracket bushing worn out
Replace the bushing if looseness found.
Tighten all nuts and bolts.

Nuts, Bolts Tightness

Perform periodical maintenance in accord with the
Periodical Maintenance Schedule
Check if all bolts and nuts on the frame are
tightened securely.
Check all fixing pins, snap rings, hose clamps, and
wire holders for security.
To this chapter contents
2. MAINTENANCE INFORMATION
Side stand
2-11