Crankshaft Inspection - Sym HD 125 Service Manual

Hide thumbs Also See for HD 125:
Table of Contents

Advertisement

Crankshaft Inspection

Use a thickness gauge to measure left and right
clearance of connecting rod big end.
Service limit: 0.6 mm
Measure the clearance of the big end at the
vertical directions.
Service limit: 0.05 mm
Place the crankshaft on a V-block, measure
run-out of the crankshaft.
Service limit: 0.10 mm
Check crankshaft bearing
Use hand to crank the bearing to see it moves
freely, smoothly and noiseless.
Check the inner ring to see it links firmly on the
bearing.
If any roughness, noise and loose linkage are
detected, replace the bearing with new one.
Caution
The bearing shall be replaced in pair.
Special tool: outer bearing puller
To this chapter contents
11. CRANKCASE / CRANK
Measure point for the crank
big end of the connecting rod.
60 mm
90 mm
Crank bearing
11-5

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Vs150Vs2Hd200

Table of Contents