Step 2 - Insert/Remove Sd Card; Step 3 - Installing The Guardcam - ESP GuardCam RF User Manual

GuardCam RF Manual_Layout 2 01/08/2013 09:27 Page 5
Step 2 - Insert/remove SD card (see Fig. 2)
 Unscrew the waterproofed cover using provided Allen key, then insert the SD card
until it automatically locks into place.
 If you need to remove the SD card, please press OFF button and take it out within
30 seconds.
 When LED light
turns green,
meaning SD card is
being read, do not
remove SD card or
data may be lost.
 To remove SD card,
push in SD card
to eject. Once to
unlock then pull out.

Step 3 - Installing the GuardCam

IMPORTANT - IF IN ANY DOUBT ABOUT THE INSTALLATION OF THIS PRODUCT,
CONSULT A QUALIFIED ELECTRICIAN

This product must be earthed

Do not mount the unit against inflammable surfaces

The motion detector will not operate correctly if it is installed:
- Near the outlet of a central heating boiler or near air conditioning plant
- Pointing directly at moving vehicles
- Within sight of reflections from moving water
- Where other lamps could shine on the detector
BEFORE ATTEMPTING ANY INSTALLATION OR MAINTENANCE, ENSURE THAT THE
ELECTRICAL SUPPLY IS SWITCHED OFF AND THE CIRCUIT FUSES REMOVED OR THE
CIRCUIT BREAKER IS IN THE OFF POSITION.
Please make sure the voltage and polarity are correct before connection. Incorrect
voltage may cause electric shock. If you are not sure, please contact your retailer.
Note: It is recommend to mount GuardCam 2M above the ground for optimum
performance, do not mount the fixture below 1.2M. See Fig. 3 for details
of performance range.
Detection range: 12M x 160° (see Fig. 3)
2m
2m
Fig. 3
4m 6m 8m 10m 12m
Fig. 2
5