Step 2 - Insert/Remove Sd Card - ESP GuardCam Manual

Installation and replacement of back up batteries
The Function of the back up batteries is to Provide power to complete a part
finished recording if a mains power outage occurs and preserve date/time
settings for a minimum of 120 hours prior to mains power being restored.
Unscrew the screw A and remove back cover. Unscrew screw B and remove
battery cover.
I Put the 3pcs "AAA" 1.5V batteries into the battery compartment and make sure
the polarity (- +) is aligned correctly.
I Replace battery cover and back cover, tightening screws carefully.
G Note: To guard against
damage from battery
leakage it is good practice
to replace batteries on a
yearly basis .
G To maintain battery back
up function please replace
batteries after a total of
120 hours of mains power
failure.
Step 2 - Insert/remove SD card (see Fig. 2)
I Unscrew the waterproofed cover using provided Allen key, then insert the SD card
until it automatically locks into place.
I If you need to remove the SD card, please press OFF button and take it out within
30 seconds.
I When LED light turns green, meaning SD card is being read, do not remove SD
card or data may be lost.
I To remove SD card, push in SD card to eject. Once to unlock then pull out.
Fig. 2
www.cctvireland.ie Lo-Call 1890 866 900 e-sales@cctvireland.ie
4
5