8
Fitting the reel stand
.01.06
Fig. 8 - 04
8
Commissioning
.02
●
Clean the machine thoroughly and then check the oil level ( see Chapter
Maintenance ).
●
Check the machine, in particular the electric leads and pneumatic connection tubes, for
any damage.
●
Have mechanics ensure that the machine's motor can be operated with the available
electricity supply.
●
Connect the machine to the compressed air system. The manometer should show a
pressure of 6 bar.
●
If necessary, set this value ( see Chapter
8
Switching the machine on / off
.03
●
Switch the machine on or off ( see Chapter
●
Setting up the machine control unit, see Chapter
unit.
Mounting and commissioning the machine
●
Fit the reel stand as shown in Fig.
●
Afterwards insert the stand in the hole in
the table top and secure it with nuts pro-
vided.
12.05 Checking / adjusting the air pressure ).
7.01 Main switch ).
8.04 Setting up the machine control
8 - 04.
12 Care and
29