Pfaff 3119 Instruction Manual page 20

Controls
Stop
●
●
●
Tacting in reverse
●
●
Tacting forwards
●
●
Basic position
●
●
Work clamp raised / lowered
●
●
P1
●
●
P2
●
●
P3
●
●
P4
●
●
Scrolling
●
20
When operated during a sewing cycle, the machine is stopped.
If operated outside a sewing cycle, the winding operation is started/stopped.
When entering the code number this key corresponds to the fi gure 1.
When moving step-by-step through the sewing cycle, all cutting procedures will
be carried out! Danger of injury if the knife engages!
Tacting in reverse through the whole sewing cycle step by step.
When entering the code number, this key corresponds to the number
Tacting forwards through the whole sewing cycle step by step.
When entering the code number, this key corresponds to the number
In the operational mode Sewing the machine moves to the basic position.
When entering the code number, this key corresponds to the number
In the operational mode Sewing the work clamp is raised/lowered.
When entering the code number, this key corresponds to the number
Quick selection key for variable and special programs.
When entering the code number, this key corresponds to the number
Quick selection key for variable and special programs.
When entering the code number, this key corresponds to the number
Quick selection key for variable and special programs.
When entering the code number, this key corresponds to the number
Quick selection key for variable and special programs.
When entering the code number, this key corresponds to the number
In the sewing mode this key is used to switch between speed display and seam pattern
display.
Using the keys described below, each of which has an LED, depending on the
mode selected, further functions can be called up. When the LED lights up
the corresponding function is activated / switched on.
2
3.
4.
5.
6.
7.
8.
9.