Sewing
Enter cut overlap
●
●
●
10
Altering the buttonhole width and seam correction
.01.04
●
●
Entering the button width
●
Entering the seam correction
●
46
No
2 0 8
Select Parameter "
208" with the corresponding plus/minus key.
With the corresponding
Conclude parameter input by switching to operational mode Sewing (LED in the key goes
off).
The buttonhole width and seam correction are only valid in the buttonhole mode
and must always be set up from the centre of the buttonhole.
Switch on the machine.
Select the function for entering the buttonhole width and seam correction (LED in the key
is on).
2 . 0
+ 0 . 0
Enter the desired buttonhole width with the left
2 . 0
+ 0 . 2
Enter the desired seam correction with the right
VA L
0 . 5
plus/minus key select the cut overlap, e.g. 0.5 mm.
plus/minus key.
plus/minus key.