Input; Summary Of The Function Groups And Parameters - Pfaff 3119 Instruction Manual

11

Input

In the operational mode Input the values of the machine parameters can be altered, e.g. for
setting up the machine or for creating/modifying seam programs.
11

Summary of the function groups and parameters

.01
100 Operating staff
200 Specialists
300 Programming (see Chapter 11.05.02, 11.05.05, 11.05.06 and 13.48.02)
400 Times (see Chapter 13.48.02)
500 Counters and speeds (see Chapter 13.48.02)
600 Service (see Chapter 13.48.02)
700 Sewing motor (see Chapter 13.48.02)
800 Access rights (see Chapter 11.03. and 13.48.02)
Operational mode Input (LED in the key is on)
101 Knife suppression
102 Stop – needle thread fault
104 Display software version
105 Type of buttonhole/type of bartack (see Chapter 9.07))
108 Number of securing seam cycles
109 Distance of the securing seam to the outer edge of the buttonhole
110 Selecting programs
111 Programming sequence 1
112 Programming sequence 2
113 Programming sequence 3
114 Sequence mode
115 Operating mode
116 Softwareversion Motorregelung
117 Key tone
201 Deleting variable programs
202 Subclass
205 Needle thread monitor
206 Copying programs
207 Entering the knife length
208 Enter cut overlap
209 Double cycle with offset stitches
210 Min. distance to bartack (distance from front edge of knife to centre of needle)
211 Number of fi nishing stitches
Input
I off
II on
I off
II on
I Off (select programs)
II On
I off
II ein
I buttonhole
II bartack
I off
II on
1 -1/51 und -1/52
2 -2/51 und -2/62
3 -2/53 und -2/63
4 -3/51
5 -4/51
6 -5/51
I off
II on
1 Full number of stitches per cycle
2 Half number of stitches per cycle
51