Other Key Functions In The Bartack Mode - Pfaff 3119 Instruction Manual

Controls
7

Other key functions in the bartack mode

.05.04
When the bartack mode has been selected, see Chapter 9.06 Selecting the operating
mode, the function of the keys depends on the screen display, see Chapter 10 Sewing.
If the program number is shown on the display instead of the bartack length, the following 3
keys serve as station keys for vario and special programs.
●
●
●
1st seam (forwards seam)
●
2nd seam (reverse seam)
●
Sewing mode / Input
●
●
Piece counter / reverse counter
●
●
22
If the bartack length is shown on the display, a previously created bartack is activated.
If the bartack length is shown on the display, a previously created bartack is activated.
If the bartack length is shown on the display, a previously created bartack is activated.
After this function has been activated, the current values of the forwards seam for bar-
tack width (left) stitch length (centre) and bartack length correction (right) are shown on
the display and can be changed respectively with the corresponding plus/minus key.
After this function has been activated, the current values of the reverse seam for bartack
width (left) stitch length (centre) and cutting width (right) are shown on the display and
can be changed respectively with the corresponding plus/minus key (does not apply to
bartack type "35").
This key can be used to switch between the sewing mode (LED off) and input mode
(LED on).
After the elimination of an error, this key is used to acknowledge the error message.
When one of these functions is selected, the other function is deactivated.
When the function is selected, the current value appears on the right hand side of the
screen, the set value appears on the screen after the key is pressed twice and can be al-
tered with the corresponding plus / minus key.
When entering the code number, the piece counter key corresponds to the number 0.