Installation And Setup - Aastra 6753i Installation Manual

Installation and Setup

The 6753i can be setup to share a network connection with another network device. Power can be provided by the sup-
plied power adapter or by an 802.3af compliant network power source or with a PoE inline power injector (optional acces-
sory). If your System Administrator has already setup your phone, please refer to the Aastra 6753i IP Phone User Guide for
call handling information or contact your System Administrator.
Direct or Shared Network Connection
The phone can be set up as a direct network connection to the Ethernet wall jack or as a shared network connection as a
pass-through if connecting the phone to a computer or another network device.
Direct Network Connection
Located at the top of the phone are two fully switched 10/100 Mbps Ethernet cable ports. The port marked with LAN is
used to connect the phone to the network, as well as provide power to your phone (if required). See
Network and to Power" on page 8
Network Jack
(if Inline power provided,
do not install the power adapter)
Shared Network Connection
To connect a network device (such as a computer) to the phone, connect an Ethernet Cable into the network port on the
top of the phone marked with PC. Plug the other end of the Ethernet cable into the network jack on the network device
you are sharing the network connection with.
Note:
The PC jack on the 6753i does not supply inline power onto other network devices. All Ethernet cables used must be
minimum category 5/5e straight-through cables, such as the cable provided with your phone.
41-001157-06 Rev 03 – 04.2012
for more information.
Ethernet
Cables
Other Network Devices
Installation and Setup
Power Adapter
Connection
To Network
To Other
Network Device
Power
Adapter
"Connecting to the
7